After being normally connected to the power supply, the desk lift motor will be input with 24V DC power through the controller. The forward or reverse signal will be transmitted to the motor by pressing the control button, then the motor for the self-adjusting desk rotates. The turbine rotates after combined with the worm. The internal screw rod is driven to rotate through the relevant transmission parts, and finally, the inner tube is driven to lift through the controller software system. The motorized sit & stand desk is composed of the electric lift desk desktop, control motor, the electric lift desk table leg, and lift desk motor. The electric lifting motor is the core accessory of the electric lift desk! Desk lift motor is a kind of low-power miniature reduction motor. The main transmission structure is assembled by driving motor (motor) and a gearbox (planetary gearheads, worm gearbox) to form a reduction device. The technical parameter range of customization: diameter: 3.4mm-38mm, voltage: under 24V, output power: under 50W, output speed between 5rpm and 1500rpm, speed ratio range between 2-2000, and output torque between 1.0 gf.cm -50kgf.cm.
Product Name: Gear Motor for Electric Lift Table
Background: The emergence of the automatic lift desk has well fulfilled the multi-functional requirements. You only need to press a button to switch between standing and sitting. At present, there are many intelligent sit & stand desks on the market, but there are still some problems such as insufficient load-bearing, too limited switchable gears (limited lifting range), short service life, high power consumption, or high noise during use. During lifting, If the speed is not well controlled, there will be stuttering.
Technical Solution: ZHAOWEI linear actuator for the lift desk is set in the lifting column. The electric adjustment, small volume and high torque can be realized by the 20mm special-shaped desk lift motor. The gearbox structure has two-stage, three-stage, and four-stage transmission changes. The reduction ratio, input speed, and torque can be changed according to the design requirements of the starting motor of the lifting column. The control system can verify the information and adjust accordingly. The desk lift motor is combined with ZHAOWEI linear actuator for the lift desk to realize stable lift of the desk and avoid jams.